Skip to main content

Delete Specific Event Correlation Policy Rule (v2.0)

DELETE 
/v2.0/api/tenants/:tenant_id/eventcorrelationpolicysets/:policy_set_id/eventcorrelationpolicyrules/:policy_rule_id

Delete a specific event correlation policy rule.

Request​

Path Parameters

    tenant_id stringrequired

    ID of the tenant.

    policy_set_id stringrequired

    ID of the event policy set.

    policy_rule_id stringrequired

    ID of the event policy rule.

Responses​

Successful Operation

Schema
    description

    Description of the event correlation policy rules.

    enabled boolean

    The enabled event correlation policy rules.

    end_time int64

    The end date in MM/DD/YYYY HH: mm format of the applied event policy rule.

    escalation_rules EscalationRule

    The alarms which have their priority escalated based on standing rule and flap rule.

    flap_rule FlapRule

    Resource flaps more than the rate specified during the defined interval, then a new flap rate exceeded alarm is generated.

    flap_duration integer

    Flap duration cannot be less than 5 minutes and more than 10080 minutes (a week).

    flap_rate integer

    Flap count cannot be lower than 2 nor higher than 512.

    standing_rule StandingRule

    Alarms standing for more than the specified period.

    priority stringrequired

    Possible values: [p1, p2, p3, p4, p5, none]

    Priority specified for the standing rule. Range from Priority 1 (P1), through Priority 5 (P5).

    standing_for integer

    Standing for duration cannot be less than 5 minutes and more than 10080 minutes(a week).

    event_codes string[]

    Possible values: [DEVICEHW_POWER_LOST, DEVICEHW_INTERFACE_DOWN, DEVICEHW_INTERFACE_HALFDUPLEX, DEVICEHW_INTERFACE_ERRORS, DEVICEHW_DISKUTIL_PARTITIONSPACE, DEVICEHW_DISKENC_SYSTEM, DEVICEHW_MEMUTIL_SWAPSPACE, DEVICESW_GENERAL_PROCESSRESTART, DEVICESW_GENERAL_PROCESSSTOP, DEVICESW_CRITICAL_PROCESSRESTART, DEVICESW_CRITICAL_PROCESSSTOP, DEVICESW_LICENSE_VERIFICATION_FAILED, DEVICESW_MONITOR_DISABLED, DEVICESW_SYSTEM_BOOT, DEVICESW_TOKEN_VERIFICATION_FAILED, DEVICESW_IMAGE_UNSUPPORTED, DEVICESW_DHCPSERVER_RESTART, DEVICESW_DHCPRELAY_RESTART, DEVICESW_DHCPSERVER_ERRORS, DEVICESW_SNMP_AGENT_RESTART, DEVICESW_SNMP_AGENT_FAILED_TO_START, DEVICESW_SYSLOGSERVERS_DOWN, DEVICESW_NTP_NO_SYNC, DEVICEIF_ADDRESS_DUPLICATE, DEVICEIF_IPV6_ADDRESS_DUPLICATE, NETWORK_VPNLINK_DOWN, NETWORK_VPNPEER_UNAVAILABLE, NETWORK_VPNPEER_UNREACHABLE, NETWORK_VPNSS_MISMATCH, NETWORK_VPNSS_UNAVAILABLE, NETWORK_VPNBFD_DOWN, NETWORK_VPNLINKCIPHERS_INCOMPATIBLE, NETWORK_DIRECTPRIVATE_DOWN, NETWORK_DIRECTINTERNET_DOWN, NETWORK_PRIVATEWAN_UNREACHABLE, NETWORK_PRIVATEWAN_DEGRADED, PEERING_EDGE_DOWN, PEERING_CORE_DOWN, PEERING_BGP_DOWN, APPLICATION_APP_UNREACHABLE, APPLICATION_IP_COLLISION, APPLICATION_UNKNOWNS_HIGH, APPLICATION_FLOWCTRL_APPUNREACHABLE, APPLICATION_FLOWCTRL_APPREACHABLE, APPLICATION_FLOWCTRL_APPWITHINSLA, APPLICATION_FLOWCTRL_APPOUTSIDESLA, OPERATOR_SIGNUP_TOKEN_DISABLED, DEVICESW_FPS_LIMIT_EXCEEDED, DEVICESW_CONCURRENT_FLOW_SOFTLIMIT_EXCEEDED, DEVICESW_CONCURRENT_FLOWLIMIT_EXCEEDED, SITE_CIRCUIT_ABSENT_FOR_POLICY, NETWORK_POLICY_RULE_CONFLICT, PRIORITY_POLICY_RULE_CONFLICT, APPLICATION_CUSTOM_RULE_CONFLICT, NETWORK_POLICY_RULE_DROPPED, PRIORITY_POLICY_RULE_DROPPED, DEVICESW_DISCONNECTED_FROM_CONTROLLER, DEVICESW_USERIDAGENTS_DOWN, SPOKEHA_STATE_UPDATE, SPOKEHA_MULTIPLE_ACTIVE_DEVICES, SPOKEHA_CLUSTER_DEGRADED, SPOKEHA_CLUSTER_DOWN, NAT_POLICY_LEGACY_ALG_CONFIG_OVERRIDE, NAT_POLICY_STATIC_NATPOOL_OVERRUN, DEVICESW_CONNTRACK_FLOWLIMIT_EXCEEDED, DEVICESW_INITIATED_CONNECTION_ON_EXCLUDED_PATH, NETWORK_ANYNETLINK_DEGRADED, NETWORK_ANYNETLINK_DOWN, CLAIMCERT_RENEWAL_RETRY_LIMIT_EXCEEDED, CLAIMCERT_RENEWAL_FAILED, CLAIMCERT_AUTO_RENEWAL_DISABLED, CLAIMCERT_RENEWALS_TOO_FREQUENT, FLAP_RATE_EXCEEDED, DEVICESW_ANALYTICS_DISCONNECTED_FROM_CONTROLLER, DEVICESW_FLOWS_DISCONNECTED_FROM_CONTROLLER, APPLICATION_PROBE_DISABLED, SITE_CONNECTIVITY_DOWN, NETWORK_STANDARD_VPN_ENDPOINT_DOWN, SECURITY_POLICY_RULE_INCOMPLETE, SITE_NETWORK_SERVICE_ABSENT_FOR_POLICY, DEVICESW_IPFIX_COLLECTORS_DOWN, SITE_CONNECTIVITY_DEGRADED, CLAIMCERT_EXPIRY_WARNING, DEVICE_CELLULAR_ROAMING, DEVICE_CELLULAR_SIM_REMOVAL, DEVICE_CELLULAR_SIM_SWITCHOVER, DEVICE_CELLULAR_SIGNAL_STRENGTH_THRESH, DEVICE_CELLULAR_INTERNAL_MODEM_ERROR, DEVICE_CELLULAR_TECH_CHANGE, DEVICE_CELLULAR_SIM_PIN_ERROR, DEVICE_CELLULAR_SIM_PUK_NEEDED, DEVICE_CELLULAR_MODEM_TEMP_HIGH, DEVICE_CELLULAR_MTU_MISMATCH, DEVICE_CELLULAR_MODEM_DETECTION_ERROR, DEVICE_CELLULAR_SIM_SECURITY_ERROR, DEVICE_CELLULAR_FIRMWARE_NOT_AVAILABLE, DEVICEHW_ION9000X722FW_OUTOFDATE, DEVICESW_APPDEF_SIGFILE_MISMATCH, SECURITY_POLICY_LIMITS_EXCEEDED, SASE_SERVICEENDPOINT_BANDWIDTH_LIMIT_EXCEEDED, SASE_SERVICEENDPOINT_BANDWIDTH_SOFT_LIMIT_EXCEEDED, VION_BANDWIDTH_LIMIT_EXCEEDED, VION_BANDWIDTH_SOFT_LIMIT_EXCEEDED, SPN_BANDWIDTH_LIMIT_EXCEEDED, SPN_BANDWIDTH_SOFT_LIMIT_EXCEEDED, DEVICE_POE_PORT_POWER_STATUS, DEVICE_POE_PORT_POWER_OVER_THRESHOLD, DEVICE_POE_MAIN_POWER_OVER_THRESHOLD, DEVICE_POE_MAIN_POWER_FAULT, DOT1X_RADIUS_SERVER_UNREACHABLE, DOT1X_DYNAMIC_VLAN_NOT_CONFIGURED, DOT1X_CLIENT_AUTH_FAIL, HUB_CLUSTER_SITE_COUNT_THRESHOLD_EXCEEDED, DEVICEHW_DISKUTIL_FRUSSD, DEVICEHW_TEMPERATURE_SENSOR, USER_ID_DIRECTORY_SYNC_FAILED, USER_ID_HUB_SELECTION_FAILED, DEVICE_POE_SHUT_CPU_TEMP_OVER_THRESHOLD, DEVICESW_INTERFACE_CONFIG_OUTOFSYNC, DEVICE_CELLULAR_INTERFACE_CONFIG_OUTOFSYNC, DEVICE_CELLULAR_MODULE_CONFIG_OUTOFSYNC, CARRIER_PERFORMANCE_DEGRADED, CIRCUIT_PERFORMANCE_DEGRADED, APPLICATION_PERFORMANCE_DEGRADED, DEVICE_ID_HUB_SELECTION_FAILED, NETWORK_VPNKEK_UNAVAILABLE, DEVICEHW_FAN_LOST, DEVICESW_MFGCERT_RENEWAL_FAILED, DEVICEHW_POWER_MISSING, SYSTEM_CIRCUIT_UTILIZATION_THRESHOLD_EXCEEDED, SYSTEM_CPU_THRESHOLD_EXCEEDED, SYSTEM_MEMORY_THRESHOLD_EXCEEDED, SYSTEM_DISK_THRESHOLD_EXCEEDED, SYSTEM_CONCURRENT_FLOW_THRESHOLD_EXCEEDED, DEVICESW_MCTD_INITIALIZATION_FAILURE, DEVICESW_MCTD_CONTENT_LOAD_FAILURE, DEVICESW_MCTD_LOG_BUFFER_FULL, ALL_INCIDENTS, ALL_ALERTS, BRANCH_GATEWAY_CLUSTER_SITE_COUNT_THRESHOLD_EXCEEDED]

    List all the event codes.

    id string

    ID of the event policy set.

    name stringrequired

    Name of the event policy set. Max 25 characters.

    priority stringrequired

    Possible values: [p1, p2, p3, p4, p5, none]

    Priority level set for the event policy rule.

    resource_ids string[]

    The resource IDs configured for a rule. Max 128 resources can be configured in a rule.

    resource_type string

    Possible values: [site, element, anynetlink, bgppeer, interface, waninterface, wannetwork, networkpolicyset, prioritypolicyset, natpolicyset, securitypolicyset, appdef, serviceendpoint, cellular_module, user_id]

    The resource on which the event policy rule is applied.

    start_time int64

    The start date in MM/DD/YYYY HH: mm format of the event policy rule applied.

    sub_resource_type string

    Possible values: [spoke, hub, public, private]

    The sub-resource type to narrow down the match criteria to more specific elements.

    suppress stringrequired

    Possible values: [yes, no, none]

    The sub-resource type to narrow down the match criteria to more specific elements.The event policy rule which suppresses or unsuppress the alarms on the resources identified by the resource type, sub-resource type, or matched event codes during the specified schedule.

    tags string[]

    A information field that can be added to identify the event correlation policy rule. Maximum 10 unique tags of length 1024 each are allowed.

Loading...